To do lists:

MR2

1. Painting
   1. Tape off areas to not be painted
   2. Sand body for new painting
   3. Remove bumpers
   4. Remove rear mud flaps
2. Driver door gear
   1. Nylon gear replacement
   2. Clean window motor
   3. Install sound deadening
3. T-Tops
   1. Install t-top anti leak guides
4. MegaSquirt ECU
   1. Mounted in trunk
   2. Possibly use the relay board and get rid of stock fuse block location in engine bay
5. Convert interior dome light to LEDs
6. Add additional interior LED lighting
7. Add LED lighting to trunk and frunk
8. Convert tag lights to LEDs
   1. Make an LED light bar above the tag that shines down. The light bar can be connected to the trunk lid (there’s an open space available for this).
   2. LED Source: http://www.oznium.com
9. Suspension
   1. Shocks
   2. Springs
   3. Bushings
   4. Tie Rod Ends
   5. Ball joints
10. Brakes
    1. Rotors
    2. Pads
    3. Caliper rebuilds
    4. Braided brake lines

4AGE - Completed and running as of 6/1/08

1. Assemble Block
2. Take flywheel for resurfacing
3. Buy exhaust bolts to assemble exhaust Didn’t have to buy bolts!
   
4. Paint exhaust header (Using 1200 degree ceramic paint, black)
5. Wrap exhaust header in “header wrap” Did not do
   
6. Paint exhaust header wrap Did not do
7. Paint exhaust system (Using 1200 degree ceramic paint, black)
8. Remove battery tray
9. Relocate battery to trunk - Moved to frunk!

4AGE Paint and Prep

1. Block
   1. Remove single broken bolt
   2. Install Freeze Plugs
   3. Wipe engine down
   4. Tape off non-painted areas
   5. Paint block with high heat engine paint
2. Muffler heat shield painting
3. Transmission
   1. Clean off all surface dir
   2. Clean input shaft area
   3. Clean clutch fork
   4. Install new throw out bearing (Need to buy grease/gun)
   5. Paint
4. Engine Bay
   1. Clean
   2. Paint (In process)